Bow Section

Version 2.0 | Last update: 08. 01. 2020

Printing

For successful assembly of bow section you need print out these parts:

Ns1

Should be printed with brim and supports. Overhang threshold of supports should be about 7% to support only 3 bridges and nothing else inside. Note green spots on picture representing supporting material.  

Copies to be printed for one section: 1
Print time: 11h 40m*

Part version: V1
STL File name: A1_Ns1_1x_v1.stl

Ns2

Can be printed without supports and brim.

Copies to be printed for one section: 1
Print time: 50m*

Part version: V1
STL File name: A1_Ns2_1x_v1.stl

Ns3

Consider use of brim.

Copies to be printed for one section: 1
Print time: 30m*

Part version: V1
STL File name: A1_Ns3_1x_v1.stl

Ns4

Use brim and supports.

Copies to be printed for one section: 1
Print time: 35m*

Part version: V1
STL File name: A1_Ns4_1x_v1.stl

* Times were measured with settings of 0.20 layer height, 40% infil, for PLA filament. Sliced with Slic3r for MK3 Prusa printer. Note, that this is not print settings recomendation. Read this

This documentation book is released under the CC-NC-SA 4.0 License.